Oveporexton Dosing Calculator
Oveporexton (TAK-861): first-in-class oral OX2R-selective agonist for narcolepsy type 1.
Pre-filled with the most-reported clinical reconstitution protocol for Oveporexton. See how 1 mL and 2 mL of bacteriostatic water change concentration and syringe-draw volume, then adjust the calculator below for your own vial.
Quick answer · Clinical protocol
A 5 mg vial of Oveporexton reconstituted with 2 mL of bacteriostatic water yields a concentration of 2.50 mg/mL. At that concentration, a 500 mcg dose of Oveporexton equals 20 units on a U-100 insulin syringe (0.200 mL). Oveporexton is typically administered twice daily.
Oveporexton reconstitution: 1 mL vs 2 mL bac water
Bacteriostatic water volume is flexible. Less water means higher concentration and smaller injection volumes; more water means lower concentration and easier dose precision. Both options below are valid for a 5 mg vial.
| BAC water added | Concentration | Volume per 500 mcg dose | Draw on U-100 syringe (units) |
|---|---|---|---|
| 1 mL | 5.00 mg/mL | 0.100 mL | 10 units |
| 2 mL | 2.50 mg/mL | 0.200 mL | 20 units |
Calculate your Oveporexton dose
Alternative Oveporexton protocols
Beyond the default above, Oveporexton is also reported in the following protocols. Use these as starting points and recalculate with the tool above.
Narcolepsy Type 1 (Phase 3 FirstLight and RadiantLight)
Clinical- Dose
- Two dose groups evaluated: 1 mg twice daily and 2 mg twice daily (with placebo comparator). Both doses met all primary and secondary endpoints.
- Frequency
- Twice daily oral administration
- Duration
- 12 weeks (Phase 3 trial duration)
The majority of participants on the 2 mg BID dose achieved wakefulness within normative range (MWT 20 minutes or more) and approximately 85% achieved ESS scores of 10 or less, comparable to healthy individuals. Cataplexy reduced by more than 80%.
Oveporexton reconstitution & storage
Oveporexton is an oral small molecule administered as tablets. No reconstitution, mixing, or dilution is required. Tablets are taken by mouth with water.
Storage conditions for the commercial formulation have not been publicly disclosed. Research-grade material should be stored as powder at -20 degrees C. Clinical trial supplies are handled per protocol-specific instructions.
Oveporexton dosing FAQ
How much bacteriostatic water should I add to a 5 mg vial of Oveporexton?
The community standard is 2 mL of bacteriostatic water for a 5 mg Oveporexton vial. That gives a concentration of 2.50 mg/mL, so a 500 mcg dose is 20 units on a U-100 insulin syringe. Adding 1 mL instead doubles the concentration to 5.00 mg/mL and halves the draw to 10 units. Less water = smaller injection volume but harder to measure precisely.
How many syringe units is a 500 mcg dose of Oveporexton?
On a standard U-100 insulin syringe, a 500 mcg dose of Oveporexton is 20 units when the 5 mg vial is reconstituted with 2 mL of bacteriostatic water (2.50 mg/mL). If you use 1 mL of bac water instead, draw 10 units (5.00 mg/mL).
What is the standard Oveporexton dose?
Clinical protocols for Oveporexton typically use 0.5 mgâ2 mg twice daily via subcutaneous injection. 500 mcg is a common starting dose. All dose groups demonstrated statistically significant improvements in MWT, ESS, and cataplexy. The 2 mg BID dose produced MWT improvement of 23.5 minutes (vs -1.2 min placebo) and ESS improvement of -13.8 points (vs -2.5 placebo).
How long does a vial of Oveporexton last at 500 mcg twice daily?
A 5 mg vial of Oveporexton contains roughly 10 doses at 500 mcg per injection. At twice daily dosing, that is approximately 5 days (about 1 weeks) of supply per vial. Reconstituted Oveporexton should generally be used within 28 days when refrigerated.
Where do you inject Oveporexton?
Oveporexton is typically administered subcutaneously. Common subcutaneous sites are the lower abdomen (at least an inch from the navel), the outer thigh, and the love handles. Rotate sites with each injection to reduce localized irritation and bruising.
Can I use sterile water instead of bacteriostatic water for Oveporexton?
Bacteriostatic water (containing 0.9% benzyl alcohol as a preservative) is strongly preferred for multi-dose vials like Oveporexton because it inhibits microbial growth and lets a single vial be used over multiple weeks. Sterile water has no preservative and should generally be reserved for single-use preparations only.
More on Oveporexton
Oveporexton overview
Mechanism of action, primary uses, and research summary
Oveporexton dosing protocols
Full clinical and research-based dosing reference
Oveporexton community protocols
Real-world usage patterns from peptide communities
Oveporexton side effects
Reported adverse effects and safety considerations
Compare Oveporexton with
Medical Disclaimer
This website is for educational and informational purposes only. The information provided is not intended to diagnose, treat, cure, or prevent any disease. Always consult with a qualified healthcare professional before using any peptide or supplement.