Klotho Peptides Dosing Calculator

Dose

50-100 mcg

Frequency

2-3 times weekly

Duration

4-8 weeks

Route

Subcutaneous

Protocol for synthetic klotho-derived peptide fragments (KP1, KP6); very limited community data

Dose

In mouse unilateral ureteral obstruction (UUO) models, KP1 was administered intravenously. Doses were not specified in standardized human-equivalent terms. KP1 showed preferential accumulation in injured kidneys after IV administration.

Frequency

IV injection in preclinical models

Duration

Acute and short-term dosing in fibrosis models

Published in Nature Communications (2022). Not applicable to human use. Route and dose optimization for human application has not been determined.

Dose

In diabetic mouse models (STZ-induced and db/db), KP6 was administered by chronic infusion. Treatment reversed established proteinuria and ameliorated glomerulosclerosis and interstitial fibrosis.

Frequency

Chronic infusion in preclinical models

Duration

Multiple weeks in diabetic mouse models

Published in Kidney International (2022). Scrambled-sequence control peptide showed no effect, confirming sequence-specific activity.

How much bacteriostatic water should I add to a 5 mg vial of Klotho Peptides?

The community standard is 1 mL of bacteriostatic water for a 5 mg Klotho Peptides vial. That gives a concentration of 2.50 mg/mL, so a 10 mcg dose is 0.4 units on a U-100 insulin syringe. Adding 1 mL instead doubles the concentration to 5.00 mg/mL and halves the draw to 0.2 units. Less water = smaller injection volume but harder to measure precisely.

How many syringe units is a 10 mcg dose of Klotho Peptides?

On a standard U-100 insulin syringe, a 10 mcg dose of Klotho Peptides is 0.4 units when the 5 mg vial is reconstituted with 1 mL of bacteriostatic water (2.50 mg/mL). If you use 1 mL of bac water instead, draw 0.2 units (5.00 mg/mL).

What is the standard Klotho Peptides dose?

Community-reported protocols for Klotho Peptides typically use 10 mcg twice weekly via Subcutaneous. 10 mcg is a common starting dose. Based on specific alpha-Klotho LR formulation; low dose emphasized due to research showing low-dose superiority

How long does a vial of Klotho Peptides last at 10 mcg twice weekly?

A 5 mg vial of Klotho Peptides contains roughly 500 doses at 10 mcg per injection. At twice weekly dosing, that is approximately 1750 days (about 250 weeks) of supply per vial. Reconstituted Klotho Peptides should generally be used within 28 days when refrigerated.

Where do you inject Klotho Peptides?

Klotho Peptides is typically administered subcutaneous. Common subcutaneous sites are the lower abdomen (at least an inch from the navel), the outer thigh, and the love handles. Rotate sites with each injection to reduce localized irritation and bruising.

Can I use sterile water instead of bacteriostatic water for Klotho Peptides?

Bacteriostatic water (containing 0.9% benzyl alcohol as a preservative) is strongly preferred for multi-dose vials like Klotho Peptides because it inhibits microbial growth and lets a single vial be used over multiple weeks. Sterile water has no preservative and should generally be reserved for single-use preparations only.